Riso 390 User Manual

※ Download: Riso rz 370 ep service manual

Enter the number of copies for the first original. Changed settings are effective until they are changed again.

Position it using the mark on the left- hand side of the glass. The changed contents are programmed and the normal mode is restored. Close the Master Roll Holder. Your model may return multiple results, some of which may contain only the parts list.

Riso RZ Series Manual - Align the mark with the mark on the guide and position the Print Drum Cylinder horizontal relative to the guide.

Riso's are famous for this, i will scrub the rubber timing roll with rubber rejuvenator and clean the steel roll with alcohol. The riso paper feed clutches are weak compared to what they were in this series you may have to replace the clutch. Use the single-sheet path top feed for graphics or charts. If you have paper in the paper path, be sure to remove it before installing rear-feed paper. Then, move the right tractor to fit the width of the paper. Then, push riso the lock lever. Then, push back the right lock lever. Place the wire guide 1 on the pull-up roller assembly 2. The paper feeds into the printer. The factory default setting for the Top of Form where the printing should begin is one 370 down from the top of the page. Raise the paper separator to the single-sheet position. Place a sheet of paper in the separator. The paper will feed into the printer. If this helps or solves the issue, please rate it and give a testimonial for my response. The loud click is alarming, but not the problem. Check the adjustments in the paper tray. To check, press the purple lever at the service front of the tray. The leading edge of the stack of paper in th etray should rise out of the tray so that the top piece of paper can be fed into the drum assembly. If the stack does not rise evenly, or will not rise, the rear adjustment is the problem. You can inspect the springs in the paper tray by removing the plastic cover that is above the white translucent roller in the tray. To do this turn over the tray and release the catches with a little screwdriver. I do not think there is a missing spring. While you have the cover off clean the lnt from manual the roller.

Ризограф Riso RZ 370 в работе
Use paper with a vertical grain direc- tion. Cause Action A master has not been correctly set. Press the key to turn on its indicator. If the A-01 master is loose, turn the right flange inward to A-34 correct it, and close the Master Making Unit Cover. Close the Master Roll Holder. If the stack does not rise evenly, or will not rise, the rear adjustment is the problem. Pull out the Master Making Unit. Open the Master Making Unit Cover, and then gently wipe the Thermal Print Head in the back of the unit several times with a soft cloth or tissue. Besides many useful functions as a printer, the machine provides you with various conveniences such as Progressive Arrow indi- cators that show the progress of the master-making and printing processes and the Receiving Tray Paper Guide that allow you to easily pick up printed copies. After closing the Master Roll Holder, remove the wrapper. Read this section before operat- ing the machine.